Thursday, June 30, 2016
I wanted to post this DIY again that I made in 2013! Check out this LINK to see how you can make your own DIY T shirt or tank top for the 4th of July!
Fourth of July is really one of my favorite holidays. What better way to celebrate our independence than to deck out your home with red, white and blue and barbeque with friends and family? I was on Fox 8 New Orleans this morning showing how to make this fun DIY. Check out the instructions below to make your own festive DIY concrete flower pots.
Cut foam core into one large rectangle – this one is 5 inches by 20 inches. That measurement will give us 4 squares within this rectangle – use your exacto knife to cut out the squares but make sure you don’t cut through the whole way.
Bend the foam core and tape it together. Place another cut out 5x5 square on the bottom. Make sure to use a lot of tape for stability. Now we have a cube (with an open top)!
Fill the the cube up an inch with concrete and then place a cup or flower pot inside to create your planting space. I used small standard sized flower pots because I can easy switch my plants out if they die or if I’m sick of them. The pots I used have drainage holes in them, so I needed to make a barrier so that the concrete doesn’t seep into my pot when it’s drying. I just used tape to seal them off. Now the drainage holes where there because the plant needs rain or water to drain out so that if doesn’t get root rot. So now we need to make drainage holes for our concrete pot. All you have to do is cut small holes in the tape and then push chop sticks into the pot and concrete. Now that we addressed drainage, we can fill concrete around the rest of the pot. Pack it tightly.
Thursday, March 17, 2016
Follow the steps below to make your own DIY 4 Leaf Clover Door Hanger:
Draw out a 4 leaf clover shape onto a piece of plywood. You can either do this free hand or use a stencil.
Use a jig saw to cut out the shape. If you are not comfortable using a jig saw or if you don’t own one, you can cut a shape out of foam core instead, using an exacto knife.
Now that your shape is cut out, we can cover the front with moss. You can buy sheets of moss at any craft store.
Use hot glue to glue the moss onto the front of the plywood. Don’t worry about cutting multiple pieces out of the moss. The seams will not show when you are done.
After you glued on all the moss, turn it around and screw in these eye hooks. This is how the clover will hang from your door or wall. Thread a ribbon through and tie.
Now its all set to hang! You can leave it how it is or you can tie a bow on the front.
Saturday, January 23, 2016
Thursday, January 21, 2016
What you will need:
- Foam core or cardboard
- Newspaper (and a lot of it)
- Box cutter
- Packing tape
- Clear drying glue
- Hot glue
- Mardi Gras beads (all the same shape/size)
Cut out a fleur de lis out of newspaper. Fold the newspaper in half so that it is symmetrical.
Trace the cut out onto foam core or cardboard (anything you have around the house)
Use a box cutter or exacto blade to cut it out.
Ball up newspaper and tape it to the cut out. You can ball up as much newspaper as you want to make more of a relief.
Now you can start gluing Mardi Gras beads onto your masterpiece. Use hot glue to adhere beads on all the edges. I like to use hot glue in the beginning because it dry quickly, although I would not use it for the whole project because it doesn't hold as well as other glues. You can use any clear drying glue to adhere the rest of the beads onto the fleur de lis.